7 - MAINTENANCE
Pre-filter - Replace
CAUTION
Fuel vapors are explosive and flammable.
Do not smoke while handling fuel. Keep fuel away from flames or sparks. Shut off engine and remove
key before servicing. Always work in a well-ventilated area. Clean up spilled fuel immediately.
Failure to comply could result in minor or moderate injury.
C0195A
1. Using a suitable tool such as pinch off pliers close the
fuel line
(1)
before the fuel pre-filter
(2)
.
NOTE:
There is no fuel shut off valve at the fuel tank. Fuel
will drain from the fuel tank if the fuel line is not closed off
before removing the pre-filter.
2. Place a suitable container below the pre-filter.
3. Loosen the two hose clamps
(3)
.
4. Remove the two fuel hoses
(4)
from the pre-filer.
5. Remove the pre-filter by pulling upward.
NHIL17CT01295AA
1
6. Install a new pre-filter.
7. Connect the two fuel hoses.
8. Tighten the two hose clamps.
9. Remove the pinch-off pliers.
10. Bleed the fuel injection system as described in
7-39
7-15
Summary of Contents for Workmaster 25S
