3 - CONTROLS AND INSTRUMENTS
Instrument cluster panel
NHIL17CT00176FA
1
The following icons and indicators will display on the instrument cluster during operation of the tractor. Become familiar
with each item and when you might see them based on the operating conditions of the tractor.
(1)
This text informs to obtain a rear Power Take-Off (PTO) speed of
540 RPM
the engine speed must be
2933 RPM
.
(2)
Fuel Gauge - Indicates the amount of diesel fuel remaining in the tank. The gauge will activate when the key
switch is in the "ON" position. It will register "empty" with the key switch in the "OFF" position.
(3)
Flasher Turn Lights -Right-hand - Operates when the multifunction switch lever is moved upwards. The flasher
warning lights will also cause this to operate. The key switch has to be in the "ON" or "START" positions.
(4)
Engine Oil Pressure Warning Light - Illuminates with the key switch in the "ON" position and remains illuminated
for a short period, after you start the engine. The light indicates low engine oil pressure only and goes out when
sufficient oil pressure is present at the oil sender. If the bulb illuminates during operation, stop the tractor immediately,
and investigate the cause.
(5)
Park Brake Indicator Light - Illuminates if the park brake is engaged with the key switch rotated to the "ON" position.
(6)
Battery Charge Warning Light - Illuminates when the key switch is in the "ON" position and goes out when the
operator starts the engine. An illuminated bulb during this operation indicates the charging system is not operating
normally.
(7)
Tachometer - Registers engine speed in Revolutions Per Minute (RPM).
(8)
Hour Meter - Records the hours and portions of hours that your tractor has accumulated regardless of engine
RPM. Use the hour meter as a guide to determine hourly service and maintenance intervals.
(9)
Cruise Control Indicator Light - Illuminates with the key switch in the "ON" position and the cruise control rocker
switch is engaged.
(10)
Cold Starting Indicator Light - Illuminates when the key switch is turned to the "PRE-HEAT" or “START” position.
When the indicator light is illuminated, the glow plugs are heating the engine combustion chambers.
3-9
Summary of Contents for Workmaster 25S
