9
6
6
.
.
O
O
p
p
e
e
r
r
a
a
t
t
i
i
n
n
g
g
m
m
e
e
t
t
h
h
o
o
d
d
s
s
■
Please read the following precautions carefully before using.
1.
Be sure to check and confirm that the power supply and voltage is correct as outlined in specifications.
2.
When carrying the product, please disconnect from wall and carry with two hands or put on a cart.
3.
Since the perforator is very heavy, be sure to place it on a solid surface.
4. Perforating capacity is based upon
PPC paper (64 g /m
2
).
a. The perforating capacity of Die Block No. 905 & No. 905L is
up to
20 sheets.
b.
Depending upon voltage, paper weight, needle diameter & needle configuration, it is possible that the
maximum of 20 sheets per perforation will not be realized.
c. The capacity for Model No. 605 and No. 705 will be 5-30 sheets depending upon voltage, paper
weight, needle diameter & configuration.
5. Die Block Model No. 905 (Pin Type)
To change a number or character, pull out the select pin and rotate the wheel freely with your finger.
When the engraved letter of each numeral, character or mark you wish to perforate is located, insert
the select pin
securely
into the number or character which is on the wheel.
Please be sure that the select pin is inserted into the wheel hole securely, otherwise it may cause the needles
to bend and the wheel to possibly sustain damage.
6. Die Block No.905L (Lever type)
To change a number or character on the wheel, rotate the lever up or down to the corresponding number or
character you wish to perforate. Please be sure to place the lever pin in the fixed position, otherwise it may
cause the it may cause the needles to bend and the wheel to possibly sustain damage. Once the lever
reaches the correct fixed position,
you will feel it lock into place
.
7. Please don’t perforate any material except for paper.
Examples are as follows: metals (paper clips and staples), cloth products, leather products, seals, resins, etc.
8. Please empty the paper chip storage container on a regular basis as over-accumulation can cause problems
by compacting paper chips into the die block.
9. The machine is designed to start the perforation upon paper insertion. If the unit continues to activate on its’
own, please disconnect and contact your local servicing dealer for assistance.
10. If paper is jammed in the die block, please disconnect and contact your local servicing dealer for assistance.
11. Please don’t perforate in a previously perforated area. Change paper position for each new perforation.
12. Over time and based upon types of materials being perforated, some wear is to be expected. If the paper is
not being perforated thoroughly, please contact your local servicing dealer for assistance.
13.
If you will not be using the perforator for an extended period, please remove the power plug from the wall.
Summary of Contents for 10 Series
Page 17: ...17 ...
