P l e a s e G i v e P a r t N o . , D e s c r i p t i o n a n d U n i t S e r i a l N o .
HIGHWAY EQUIPMENT COMPANY
16
97372-B
Page Rev. A
GENERAL SAFETY RULES
Installation Section
5.
Do not weld on vehicle
frame as such welding
can lead to fatigue
cracking and must be
avoided. When drilling
holes in frame member,
drill only through the
vertical web portions
−
do
not put holes in top or
bottom flanges. Refer to
truck manufacturer’s
recommendations.
6.
Be sure that welds between mounting bars and sill or between mounting angles and spreader cross
sills are sound, full fillet welds. Center mounting angles so that good fillet welds can be made on
three sides—an edge bead weld is not a satisfactory weld for this service. Use dry, E6013 or E7018
rod for normal steels. On stainless steel bodies use SAE grade 5 bolts—welding is recommended if
type 308 welding rod is available.
7.
Install controls so they are located for convenient use. Position them so they do not interfere with
any vehicle control and they do not interfere with driver or passenger or with access to or exit from
the vehicle.
8.
Check for vehicle visibility, especially toward the rear. Reposition or add mirrors so that adequate
rearward visibility is maintained.
9.
Add Caution, Warning, Danger and Instruction decals as required. Peel off any label masking
which has not been removed.
10.
Install all guards as required.
11.
Check installation completely to be sure all fasteners are secure and that nothing has been left
undone.
Summary of Contents for L3020G4
