- 37 -
L4000G4
www.NewLeader.com
(800) 363-1771
307074-AA-I
Insert Installation
Use only lifting devices that meet or exceed OSHA standard 1910�184� Never exceed
work load limits or lift equipment over people� Empty spreader before lifting� Loads
may shift or fall if improperly supported� Failure to comply with this requirement could
result in death or serious injury�
Before installing the insert:
Parts Needed:
Description
Qty
MultApplier
1
Capscrew - 1/2 x 1 1/4 Grade 8
8
Flat Washer - 1/2 Grade 8
16
Lock Washer - 1/2 Grade 8
8
Hex Nut - 1/2 Grade 8
8
1� Make sure rubber sealer hardware is loose� If not, loosen�
Figure 4A
Figure 4B
2� To install insert:
a� Figure 4A - Hoist insert into position and slide between main bin’s side sheets�
b� Figure 4B - Align insert’s and main bin’s front and rear mount brackets�
c� Make sure insert is resting on inside of main bin, and not resting on tops of side sheets�
d� Release tension on hoist but do not remove�
Insert Installation Instructions
