- 50 -
GPS Offsets
Editing the task controller GPS offset settings will
determine drop point of material behind chassis�
• Select Towed or Self Propelled and enter GPS
Offset using keypad�
• For single axle towed units, enter the distance
from the center of the hitch pin to the center of the
axle (a)� Then enter the distance from the center of
the axle to the center of the spinner disc (b)�
• For self-propelled units, enter the distance from
the center of the rear axle to the center of the
spinner disc (a)�
• NOTE: For units and trailers with tandem axles,
use the center of the tandem for measurement
reference point�
• Press
to continue�
Towed
Self-Propelled
System Setup Summary
• Verify all settings are correct� Press
to
continue or
to go back and adjust as
necessary�
Configuring Auxiliary Switches
•
Switches must be configured before calibration.
• Switchbox switches need to be mapped� Use the Display Monitor’s operations manual to map all
switches as necessary�
Controller Operations
