EN - 13
4. USE OF PRODUCT
4.1
hob ControlS
The appliance is operated by pressing
buttons, confirmed by displays and audible
sounds.
1
7
8
9 10
11 12 13 14
2
3
4
5
6
1-
Heater display
2-
Activate/Deactivate heater
3-
Timer display
4-
Timer function cooking zone indicators
5-
Triple zone indicator
6-
Dual zone indicator
7-
Dual/triple zone selection
8-
Heat setting/timer decrease
9-
Activate/Deactivate timer
10-
Heat setting/timer increase
11-
Decimal point
12-
Key lock indicator
13-
Key lock
14-
On/Off
Mode Descriptions
Stand-By-
Mode
S-Mode
Mains supply is applied
to the hob control and all
heater displays are off or
a residual heat display is
active.
Operating-
Mode
B-Mode
At least one heater display
shows a heat setting
between ´
0
` and ´
9
`.
Lock Mode
VR-
Mode
The hob control is locked.
Switching the Appliance On and Off
If the appliance is in Stand-By mode, it
is put in Operating mode by pressing the
On/Off button for at least 1 second. A
buzzer will sound to indicate the successful
operation.
A “
0
” will appear on all heater displays and
all decimal points corresponding to the
heaters will flash (1 second on, 1 second
off).
If there is no operation within 10 seconds,
the display on all heaters will switch off.
If the displays do switch off, the heater will
be sent into Stand-By mode.
If
is pressed for more than 2 seconds (in
Operating mode), the appliance is switched
off and is sent into S-Mode again. The
appliance can be switched off by pressing
at any time; even if other buttons are
pressed simultaneously.
If there is any residual heat from a heater,
this will be indicated in the corresponding
Heater Display with a '
H
'.
Selecting a Heater
If a single heater is chosen with the
corresponding Activate/Deactivate Heater
Button , the decimal point of the Heater
Display will flash. For the selected heater,
the heat level can be set between 1 and 9
by pressing the Heat Setting Buttons
or
.
The buttons must be pressed within 3
seconds of selecting a heater, otherwise the
heater selection will be erased and the heat
setting decimal point will disappear. If there
is no further operation within 10 seconds,
the heater will revert back to S-Mode.
The heat setting can always be changed by
pressing or
. The available settings
are between 1 and 9.
Each button operation or each display
change is accompanied by a buzzer sound.
Switching On the Dual and Triple Zones
Switching on the Dual Zone
The Dual Zone can be activated by
pressing
, after a heater and its
corresponding desired heat level (between
1 and 9) is selected. This is confirmed by
a buzzer sound. At the same time, the
corresponding Dual Zone Indicator will
illuminate. To deactivate the Dual Zone,
press
again.
Switching on the Triple Zone
Similar to activating the Dual Zone, a triple
zone can only be switched on if the basic
zone of a heater has been selected and its
corresponding heat level, between 1 and 9,
has been set. This will be indicated by the
illumination of the heater's corresponding
decimal point.
If
is pressed, the signal will sound and
the Dual Zone Indicator will illuminate. If
is pressed a second time, another buzzer
will sound to indicate the activation of the
Triple Zone. The Triple Zone Indicator will
illuminate to confirm this.
