80
RU
персонализировать свой аквариум, можно легко запрограммировать таймер по приведенным ниже инструкциям (за
исключением модели NMO 20).
ВНИМАНИЕ
: при первом подключении электропитания система освещения выполнит калибровку сенсорных кнопок.
Для их подключения достаточно на несколько мгновений прикоснуться пальцем к нужной кнопке.
Для программирования таймера выполните следующие операции:
1. Таймер позволяет автоматизировать включение и выключение только дневного света (белые светодиоды) на
требуемое время после их программирования. Синие светодиоды будут включаться на час раньше и автоматически
выключаться через час после включения/выключения светодиодов дневного света (белых светодиодов). Синие
светодиоды не могут программироваться при помощи таймера.
белые светодиоды 9:00-17:00
Синие светодиоды 8:00-18:00
ON
2. Войдите в функцию программирования, нажимая на несколько мгновений обе кнопки включения светодиодного
освещения (белого и синего): синие светодиоды начнут мигать.
3. Нажмите кнопку «+1h» (кнопка белого светодиодного освещения) столько раз, сколько часов должно быть включено
это освещение. При каждом нажатии включение белых светодиодов будет подтверждать сделанный выбор. (НАПРИМЕР,
если вы желаете, чтобы свет в аквариуме каждый день включался в 9.00 и выключался в 17.00, необходимо один раз
начать программирование в 9.00 и нажать кнопку «+1h» 8 раз).
4. Для подтверждения и выхода из программирования нажмите кнопку «OK» (кнопка синего светодиода).
5. Белые светодиоды будут мигать столько раз, на сколько часов было запрограммировано включение дневного света.
ВНИМАНИЕ
: по завершении
первого программирования
одновременно на заданное время включатся как белые,
так и синие светодиоды. Затем,
после первого включения
, синие светодиоды будут включаться на 1 час раньше
белых и будут выключаться через час после них.
6. При ошибке программирования таймера повторите процедуру с пункта 2 по пункт 4.
7. Для отключения таймера необходимо войти (пункт 2) и выйти из программирования (пункт 4) без нажатия кнопки
«+1h» (кнопка белого светодиодного освещения).
ПРИМЕЧАНИЕ:
1. ВНИМАНИЕ: При прерывании подачи электроэнергии, даже на несколько секунд, настройка таймера
стирается и требуется его новое программирование.
2. При ручном выключении дневного света (кнопка белого светодиодного освещения) при включенной системе
освещения, управляемой таймером: при последующем ручном включении белые светодиоды будут мигать столько
раз, на сколько часов запрограммировано их включение.
3. При ручном включении дневного или ночного света (кнопка белого/синего светодиодного освещения) при
выключенной системе освещения, управляемой таймером: если не выполняется действий вручную, белые и синие
светодиоды будут оставаться включенными до последующего автоматического выключения таймером.
4. Если устройство не отвечает на команды, отключите электропитание, отключая блок питания минимум на 15 секунд,
и повторите процедуру настройки.
V.g ВКЛЮЧЕНИЕ АКВАРИУМА
ВНИМАНИЕ
: Подключать электроприборы к электросети только после оснащения аквариума по своему желанию и
заполнения его водой.
1. Уровень воды должен всегда поддерживаться от минимума 3 до максимума 5 см от верхнего края (рис. 25). Это
позволяет правильно работать фильтру, пропуская воду через фильтрующие материалы.
2. Поместить один или несколько фильтрующих патронов в специальное отделение для фильтра.
3. Вставить штепселя в электрические розетки, строго соблюдая инструкции по безопасности, приведенные в главе
I. С этого момента токоподводящие кабели больше не должны отсоединяться, если только не требуется проведение
периодических операций очистки и техобслуживания.
4. Проверить функционирование различных аппаратов (при неполадках см. гл. VIII):