EN
www.newair.com
10
OPTIONAL ANTI-TIP BRACKET INSTALLATION
This unit comes with optional anti-tip brackets that help prevent sliding or
tipping. If you want to install them, follow these instructions:
1.
You can use one (or both) of the anti-tip brackets. Brackets are meant to
be screwed into the floor for the back adjustable feet of the fridge to slide
and lock into.
2.
If using both brackets, place the brackets on the floor and position them in
their final location before securing them to the floor with screws. Brackets
should be 22 ¼ inches (565mm) apart between each center of bracket (red
dots in each bracket below). Make sure the brackets are lined up with each
other so that both back feet can slide into them equally. You may find it
helpful to measure the distance between the centers of the two back feet,
just to be safe.
3.
Please note: the brackets will stick out under the sides of the fridge once
installed, but not the back. Use the graphic below as a reference, in case it
affects your final placement.
4.
While the brackets are in position on the floor, mark the position of all 4
holes on each bracket.
Before drilling any holes, double check all
measurements and place the fridge near the brackets to check your
accuracy. Bracket openings should line up with the adjustable feet on the
back of the unit.
Use a 5/16 drill bit to make holes for the plastic anchors.
Insert the plastic anchors.
5.
Once plastic anchors are in place, use the screws to secure the brackets in
place. Alternate turning all four screws on each bracket to prevent the
bracket from moving too much from the original location.
