PCD / Bolt Hole Circle
35
Mill Functions
The DP1200 calculates positions for a series of equally spaced holes around the circumference of a
circle. Once the parameter data is entered, the DP1200 displays the distance to the next hole.
The operator works to zero for each hole location. See example (
Fig 1
).
Note:
This function only operates in the axes that have been setup in the plane (See Page 24 - Plane
Setup).
To select
PCD
(Bolt Hole Circle)
Example
Enter 1st centre
coordinate
Enter 2nd centre
coordinate
Enter the diameter dimension
Enter the number of holes required
Enter start angle required
Note:
The PCD will be calculated from the 3 o’clock position, counter-clock
wise. Enter the angle as a negative value if it is given as clockwise
from 3 o’clock.
Enter end angle required
Note:
End angle must equal start angle for a full circle PCD routine.
Summary of Contents for dp1200
Page 1: ...User Manual DP1200 Digital Readout...
Page 2: ......
