Situation
Check Items
Solution
The UPS switches to if any power strip is
1. Do not use power strip.
battery mode then
connected
2. Replace the wall
back to Utility mode, to the UPS.
receptacle/cable cord plug.
when connected
Verify if there is any
device is turned on.
damage to the utility
Or, the UPS
Wall Receptacle or if
switches back and
the cable cord plug is
forth between battery faulty.
and Utility.
Strange noise and
Immediately shut down the whole
smell
System. Disconnect the power from
the UPS and call for service.
UPS is unable to
Check that the battery connectors are
provide backup
fully engaged. Allow the battery to
power source
recharge if the batter is weak. If
problem persist after recharging,
replace the battery. If problem persist,
consult your local dealer for technical
assistance.
Note When the Fault LED is illuminated, press and hold the key to check the error code.
The error code is represented by the five 10% 100% bar LEDs. Each bar LED represents a
number as shown in the figure below.
For example, the fig. below showed the 100% bar LED, 75% bar LED & illuminated when the
key is pressed. The error code shall be 1 + 2 + 8 = 1 1 , or Er11, which indicate that the UPS is over-
temperature.
Summary of Contents for 1000-3000VA
