Newco KK airpot, Service Manual

NEWCO ENTERPRISES, INC. 

 * www.newcocoffee.com * www.thermalcarafes.com * 1.800.325.7867 * 

June 5, 2012 

5

Cleaning The Lid Assembly - Continued: 
 

 
Let all parts air dry and assemble in reverse order. Wipe outside of the lid with clean towel. 

 
Slide the lid back into the pivot post by holding the lid at 10-degree angle as shown in figure-1. 

 
Push on the top of the lid to close it in place. 
 

Cleaning Of The Brew-thru Stem Assembly: 
 

During the brewing and pumping of the coffee, coffee goes into the server through the middle stainless steel pipe and 
comes out through the outer stainless steel pipe via pouring spout and into the cup. These tubes and the pouring spout 

will have coffee residue build up which requires cleaning every week. 
 

Remove the bellow cap by pulling away from 
bellow as shown in figure-3. 

Remove spring and clean with hot soapy water. Clean 

the bellow with warm soapy water with the help of a 
brush, figure-4. Make sure not to puncture. 

Lift the lid assembly and remove the brew-thru stem 
assembly, figure-5. 

Remove the bottom gasket from the stainless steel tubes, 
figure-6.    

Fig-3 Fig-4 

Fig-5 Fig-6