12
CAROUSEL:
1. To remove the two center pieces from the 6 tray supports, free one slot at a time in the center piece by
squeezing the 2 prongs of the tray support together and pulling the center piece away from the prongs
while holding pressure on the center piece to keep other depressed prongs from re-latching. Do this on
all 6 slots of the center piece, and it will pull free from the tray supports.
2. To remove the 6 tray supports from the carousel, squeeze the 2 prongs together (through the slots in the
carousel), and pull the tray supports out of the carousel slots.
BASE:
1. To remove the carousel rollers, lift the rollers from their retaining bosses on the base.
2. The roller shaft can be removed from the rollers by removing one of the “E” clips.
3. Remove the steel tube from the base by removing the screw at the base of the tube.
4. Remove the feet from the base by removing the two screws and the wing nut on top of the base. Remove
the foot cup and the foot base from underneath the base.
5. The electrical wire that supplies power to the coin box can be removed by pulling the wire down out of the
steel tube and out from underneath the tabs on the base. Also, remove the nut on the jack on the lower left
side of the base. Pull the wire and the jack out of the base.
Carousel
Base
