4
Installation
1. Place Vista Vend on a sturdy, level, flat,
surface.
2. Plug the AC to DC Adaptor into a 120-volt
AC receptacle.
3.
Plug the AC to DC Adaptor power cord into
the Vista Vend’s receptacle located on the
back of the lower left side.
*See Figure 1
Operation : Cash Box Removal
1. Unlock the front cover by inserting the key
into the lock and rotating it 1/4
th
turn
clockwise.
2. Remove the front cover by pressing in on the
lower right corner of the cover
(“A”).
Rotate
until cover has proper clearance for removal.
Lift the front cover from the vendor and set it
aside.
*See Figure 2
*Note that the front
cover can be stored by setting it on the back
cover during route servicing.
3. Rotate the carousel by grasping the blue
rotation ring of the carousel and rotating it
until one of the three 120-degree segments of
trays is centered in the service opening.
4.
Grasp the horizontal slot
(“C”)
in the center
of the top tray and lift the segment out of the
vendor. Set the segment of trays on a flat
surface and telescope all four trays down to
one level.
*See Figure 3
5. Remove the coin box by rotating the coin box
counter-clockwise and aligning the “Remove-
Install” arrow on the coin box with the
reference arrow below. Pull the coin box out
horizontally and set it aside.
*See Figure 4
Fig 1
Fig 2
Fig 3
Fig 4
Power
Outlet
Key Lock
A
Rotating Ring
C
