5. OPERATION INSTRUCTIONS
Liquid Crystal Display (LCD)
1 – Low Battery indicator; 2 – Reticle (cross or rectangular selectable);
3 – Units of measurement (Yards, Meters, KMH,
MPH or Degrees); 4 – Measurement result;
5 – Target Quality indicator (optional); 6 – Laser Active indicator
7 – Over 100m indicator (optional).
Fig. 3
8
The displayed statistical qualification of the reflected signal
characterizes variation in expected accuracy of measurements. At
qualification
HIGH
the accuracy of measurements is stated as
±
1m
±
0.1%. At lower rates of statistical qualification the
expected accuracy may marginally degrade.
Please note: this is an optional feature.
The display presents message
LOW BAT
– when voltage of the
primary 9-volt battery drops below 7.2 volt. At this point the
System is still functional but the battery should be replaced as
soon as possible. The System can operate at the voltage level
above 7 volt.
The System remains in the active displaying state for 10 seconds
after pressing of any of the operating buttons and after 10
seconds enters the passive low power state.
Alkaline or lithium type of batteries capable to sustain current
drain up to 150 ma should be used for powering the System.
13
4
6
2
7
1
5
3
