17
Setup
and
Data Recall
modes have submenus, so when A button
is pressed to select these modes the unit automatically enters the
corresponding submenu. In the same way as with the mode
switching M button switches between submenu items and A
selects the needed one. When A button is pressed from the
submenu the unit comes into
Ready to Measure
mode with the
selected parameter.
If no button is pressed for 8 seconds the unit leaves the current
mode, in
Ready
mode it switches off. Next time the unit is turned
on it assumes the last chosen combination of the four
Ready to
Measure
mode parameters.
Note:
On a special request menu of a particular unit can be
simplified to show only required modes.
Data Recall mode
In
Data Recall
mode results of the last 10 measurements can be
displayed.
Measurement results are saved in on-board memory in sets
depending on the parameters set for measuring, for instance, if
only distance is measured - the set will consist of one number, if
distance and azimuth are measured – the set will consist of two
numbers.
To enter
Data Recall
mode press M button in
Ready to Measure
mode until
rEc
is displayed and then press A button. First
Summary of Contents for LRM 2000PRO
Page 2: ...ii...
