18
measurement set number (display name:
rEc
) will start
flashing.
Pressing M button moves the unit along the list of measurement
set numbers and measurement results:
rEc
1
, distance 1, elevation 1,
rEc
2
, distance 2, elevation 2,
rEc 0
, distance 0, elevation 0.
If either elevation or distance was not measured it will not appear
in the list.
Measurement sets are numbered in reverse order: first recalled
set is the result of the last measurement.
Pressing A button at any moment within the list of recalled
results (or pressing M button at the end of the list) brings the unit
to
Ready to Measure
mode.
Choosing
cLr
in
Setup
mode will erase all measurement data.
Setup mode
To modify the four
Ready to Measure
mode parameters:
Enter Setup mode.
With word
Ready
on the display press M button till display
name
COdE
is displayed and press A button.
Select the desired parameter modification (see table below).
Press M button till the code name of the desired parameter is
displayed and press A button.
Summary of Contents for LRM 2000PRO
Page 2: ...ii...
