More user manuals on
13
Note:
Even with target selection logic the unit may not always be
able to range the desired target as its reflectivity may be too low
to produce enough laser beam reflections for statistically reliable
calculation. A warning will be displayed if the result is not
statistically reliable. See more about target reflectivity in
Additional display information
.
Operation and service modes
Pressing Mode button (5, Fig.1.1) in
Ready
mode switches the
unit between modes of operation. To activate any desired mode
from the menu you must confirm your selection by pressing the
Action button (Fig.1.1). The unit has the following modes of
operation:
Ready
– Unit is ready to perform measurements
dFLt
– sets default mode of operation with factory settings
1
GAtE
– sets gating measurement mode
Std
– allows the user to select single action measurements:
o
Distance only (
d)
o
Compass Only (
C)
o
Elevation Only (
E)
o
Speed Only
(S)
o
Height Only
(H)
o
Speed + Distance (
Sd)
o
Di Elevation (
dE)
Unit
– allows the user to select units of desired
measurements:
