5.2. Operation with image stabilization
-
Extract the battery cartridge. To do this, rotate the
compartment cover (1) counterclockwise at quarter of the
circle. The battery cartridge turns loose and can be extracted
easily from the body of the unit.
Note:
Don’t apply extra
strength to the handle!
-
Insert six AA batteries into the cartridge observing correct
polarity, which is marked on the cartridge bottom.
-
Place the cartridge with batteries into the power supply unit
and lock it with the cover (1), rotating it clockwise at quarter
of the circle.
Note:
Don’t apply extra strength to the handle!
-
In order to power the unit from the car lighter socket,
connect the supplied DC converter with the socket (8). The
binocular will switch to the external power source
automatically (the absence or presence of the battery
cartridge does not tell on the unit workability).
-
Turn on the device by setting supply voltage switch (5) to
ON position and check the power supply unit for proper
operation (the indicator (4) must glow brightly).
-
In no less than a minute, pull with your thumb the lever (7)
in the arrow indicated direction in order to engage the
stabilizing mode and hold it in this position while observing.
8
ATTENTION!
It is not allowed to engage the stabilizing mode
of the device when the power supply control
indicator is not glowing, or in less than a minute
after device has been turned ON.
After you have finished the observation
,
release the lever (7). The lever should return to the initial
position. Now the stabilizing mode is switched off. Turn the
power switch (5) into the OFF position.
6. STORAGE AND MAINTENANCE INSTRUCTIONS.
Warning!
After transportation or keeping the device at temperature
lower than –25
°
C (–13
°
F), the device must be warmed up to ambient
temperature for at least 6 hours before operating.
9
