The Newer Technology Power2U AC/USB wall outlet offers a clean, convenient, and centralized location to charge and/or
power mobile devices along with powering traditional AC powered “plug in” items. It’s an easy DIY install on any 20A electrical
circuit and provides a flush, standard wall outlet appearance that blends in seamlessly with residential environments.
By incorporating both traditional three prong AC wall sockets along with USB ports, the Power2U AC/USB wall outlet enhances
living and working spaces by eliminating the clutter created by multiple cables and unsightly bulky power adapters.
CAUTION: Please read before installing!
• A video installation guide is available at: http://www.newertech.com/p2u-install
• Failure to follow these instructions can cause death or permanent injury. Do not work on live electrical circuits!
• This product is for indoor and permanently installed use only.
• Do not place the device to be charged in direct sunlight or near direct heat, as this will affect the charging function.
• Disconnect the USB cable from the USB socket when not in use.
• It is normal for the battery in the device being charged and the USB charger itself to generate some heat during the
charging process.
• Install the device in accordance with all national and local electrical codes.
General Information:
• This product is a 2-in-1 electrical wall socket. It can be used as a standard 20A 120V electrical receptacle, as well as for
charging products that utilize a USB connection up to 2.5A. It is ideal for charging electronics such as iPhone, iPad, iPod, MP3
players, PDAs, GPS receivers, gaming consoles, and any other devices that charge using a USB connection.
• The Newer Technology Power2U uses the most advanced IC control system in the world, and provides multiple levels of
protection to your device being charged.
• The Newer Technology Power2U is manufactured from high quality polycarbonate resin and all internal components have
been UL approved.
Identify Cables / Wires
• Do NOT install the Newer Technology Power2U wall outlet into an electrical box that is smaller than 16 cubic inches. If your
electrical box contains more than 4 wires (not including ground wires), verify that it’s capacity is large enough to
accommodate this device before proceeding. Do not overfill the electrical box!
Wire and Wire Connections
• The 20A Newer Technology Power2U is designed to work with either solid wire or stranded wire, 12 AWG. When attaching
the wire to the Power2U, please refer to the drawings below to ensure proper connection:
Wi
re
Wire
13mm
Strip wire 13mm (1/2”)
Insert wire under screw block and
torque to 14 inch-pounds. Then, bend
the wire 90º after assembly to aid
insertion into the electrical box.
Brass
Screws
Silver
Screws
Green
Screw
Brass screws = Hot (Black Wire) terminal
Silver screws = Neutral (White wire) terminal
Green screw = Ground (Bare or green wire) terminal
20A-TR Power2U
®
Left side has silver screws,
and “W” near terminals.
