Page 5 of 5
STEP 6
Align the panels and door parallel with the sides and
front of the tray. Check the magnet visually to ensure it is in
contact down the length of the door and that the door is
parallel with and has an even gap between the door and
bottom rail. Secure the side panels by drilling through the
panels onto the wall profiles. Use a 3mm drill bit. Fix with two
of the #6 x 12mm square drive screws to each side at top and
bottom.
Check that the door swings freely and adjust on the pivot
block if required. Tighten all screws including those on the
door glass clamps. Insert top braces (J) into the top of each
fixed panel corner post. The braces are not interchangeable
and fit each side independently. Secure in place by drilling
through the holes on the centreline of the extrusions and
fixing with 3 or 4 of the #6 x 12mm CSK
screws to each side. Silicone around the external perimeter of the unit. Do not silicone inside the unit
and do not silicone the fixed panels to the wall profiles other than as directed in STEP 1. Allow 24hrs for
silicone to cure before using the unit (Diagram 6).
STEP 7
Should the magnet fail to hold door closed check both magnets are in contact 100% across the
width of both magnets, if not, adjust door glass on hinges. If this does not solve the problem remove the
nylon retainer from the top of the magnetic strip on the door only, remove the magnetic strip, turn 180°
(top to bottom) and refit.
STEP 8 6mm frameless door only
Push fit the four chrome pivot block covers in position on the glass
clamps, to cover screw heads. Cut and fit the splashguard to the bottom of the door in two pieces, one
on each side of and butting against the chromed pivot cover.
NB: If the glass clamp twists, and the door drops, remove the door glass, take off the glass clamps,
thoroughly clean the inside faces of the glass clamp, and the area on the glass where the clamp will be re-
located, with methylated spirits (not turpentine), reposition the clamp, and refit the door glass.
CONTACT US
.
NEWLINE HELPLINE
0508 NEWLINE
(0508 639 5463)
Phone: 09 444 2053
Fax: 09 4430044
Email: info@ newline.co.nz
www.newline.co.nz
