Page 9
Raymor Showers / Pivot Door Set
INSTALLATION STEPS / Alcove
Configuration
STEP 1
1. Mark out the Wall Channels up the wall as indicated to establish the outside boundary line.
Tiling Note: Some authorities do not allow the waterproof layer to be penetrated. Use Bostik V60
to fix Wall Channels and allow to cure as per manufacturers instructions.
STEP 2
1. Slide the Wall Channels onto each side of the door assembly.
2. Install the door assembly complete with Wall Channels into position.
3. Apply silicone to the back of the Wall Channels and fasten at the boundary line.
4. Even out the door frame within each wall channel.
5. Square up the door frame, door and ensure the magnetic door catch is in line.
15mm
Wall Channel Final Position