7
INSTALLATION
7
8
A
A1
A2
ADJUST THE SLIDING DOORS USING
THE SCREWS LOCATED ON THE
BOTTOM OF TOP ROLLER ASSEMBLIES.
ADJUST ROLLERS SO THAT THE
SLIDING DOORS ARE PARALLEL TO
EACH OTHER.
NOTE: DO NOT OVER TIGHTEN TOP
ROLLERS AS THIS WILL CAUSE THE
BOTTOM ROLLERS TO JAM AND BREAK
!
A2
A3
A1
ENSURE THAT THE CHOSEN POSITION IN 1A
AVOIDS DRILLING THROUGH THE GLASS.
!
O 0.32
SCREW M4x10
CHECK FOR LEVEL
VIEW FROM INSIDE
Adjust the sliding doors as shown in the illustration below.
A. Double check the frame alignment including levelling the top horizontal Rail to ensure that
the whole frame sits square on the shower.
% )URPWKHLQVLGHDWWDFKWKHZDOOFKDQQHOVZLWK0[VFUHZVWRWKH̍[HGJODVVH[WUXVLRQ
C. Put bump stop covers on.
IMPORTANT NOTE:
Check detail (A1) for screw position so the glass is not touched.