2
15272 Newsboy Circle
Huntington Beach,
CA 92649
Phone: 714-751-0488
Fax: 714-372-7930
E-Mail: techservice@newmarpower.com
PoweringTheNetwork.com
1. SCOPE
This manual provides safety and installation guidelines as well as information on tools and wiring.
Contents
(1) ea. SNMP Manual
(1) ea. SNMP card-Installed
(0) ea. Manual Bypass Switch-optional
(1) ea. DC Input connector (red & black)
(8) ea. Mounting bracket hardware:M4 x 5 mm, Flathead Phillips head screw, black
(4) ea. Rack mounting screws,#10-32 x ½”, Pan head Phillips head screw
(4) ea. Rack mounting screws,#12-24 x ½”, Pan head Phillips head screw
(2) ea. Rack mounting brackets, 19”
2. SAFETY INSTRUCTIONS
WARNING: This chapter contains important safety and operating instructions. Read and keep this manual for
future reference.
1. Before using the UPS, read all instructions and cautionary markings on the unit, the batteries and all appropriate
sections of this manual.
2.
CAUTION –
To reduce risk of injury, charge only deep-cycle lead acid type rechargeable batteries. Other types of
batteries may burst, causing personal injury and damage.
3. Do not disassemble the unit. Take it to a qualified service center when service or repair is required. Incorrect
re-assembly may result in a risk of electric shock or fire.
4. To reduce risk of electric shock, disconnect all wirings before attempting any maintenance or cleaning. Turning off
the unit will not reduce this risk.
5.
CAUTION –
Only qualified personnel can install this device with battery.
6.
NEVER
charge a frozen battery.
7. For optimum operation of this unit, please follow required spec to select appropriate cable size. It’s very important to
correctly operate this unit.
8. Be very cautious when working with metal tools on or around batteries. A potential risk exists to drop a tool to spark or
short circuit batteries or other electrical parts and could cause an explosion.
9. Please strictly follow installation procedure when you want to disconnect AC or DC terminals. Please refer to
INSTALLATION section of this manual for the details.
10. Battery breaker (60A) is provided as over-current protection for the battery supply.
11. GROUNDING INSTRUCTIONS -This unit should be connected to a permanent grounded wiring system. Be sure to
comply with local requirements and regulation to install this unit.
12.
NEVER
cause AC output and DC input short circuited. Do NOT connect to the mains when DC input short circuits.
13.
Warning!!
Only qualified service persons are able to service this device. If errors still persist after following
troubleshooting table, please send this unit back to local dealer or service center for maintenance.
