© 2020 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
38
APPLIANCES
For more information about the
operation of the refrigerator
installed in your coach see
the following information that
matching the manufacture and
model series of your particular
refrigerator.
WARNING
!
Most propane gas appliances used in recreational
vehicles are vented to the outside of the vehicle.
When parked close to a gasoline pump, it is possible
that the gasoline fumes could enter this type of
appliance and ignite the burner flame causing a fire
or explosion. Use caution when refueling.
WARNING
!
Do not bring or store propane cylinders, gasoline, or
other flammable liquids inside of the vehicle. Failure
to comply could result in fire or explosion.
Norcold Four Door Refrigerator with Built-In Ice Maker
Operation (Model: 1200 and 1210 Series)
Provides basic operation instructions for a Norcold Four Door Refrigerator with Built-In Ice Maker (Model: 1200 and
1210 Series).
•
120 volts AC: 108 volts min.-132 volts max.
•
12 volts DC - control voltage: 10.5 volts min. - 15.4
volts max.
The refrigerator operates on these energy sources.
Operation out of these limits can damage the refrigerator
electrical components and will void the warranty.
AC Operation
The refrigerator control panel is between the freezer
compartment and the fresh food compartment.
To maintain the operating control functions of the
refrigerator, a 12 volt DC power supply is necessary.
The refrigerator receives DC power from the 12 volt
system of the vehicle; either an auxiliary battery, a
converter, or the vehicle engine battery.
Control Panel
The ON / OFF button [30] starts and shuts down the
refrigerator:
1. To turn on the refrigerator, push and release the ON /
OFF button.
2. To turn o
ff
the refrigerator, push the ON / OFF button
for one second and then release.
ON/OFF BUTTON
The SET TEMP button [32] controls the temperature adjustment of the freezer and the fresh food compartment.
1. Push the SET TEMP button and the temperature setting (the numbers “1-9”) show in the center display [33]. The number
“9” is the coldest temperature setting.
2. Push and hold the SET TEMP button and the temperature setting changes.
3. Release the SET TEMP button when the temperature setting that you wish appears.
4. After ten seconds, the temperature setting will go out and only a green power ON light remains.
NOTE: Push and release the MODE button to show “AC”, the current mode of operation, in the center display for 10
seconds.
5. If 120 volts AC is not available to the refrigerator:
•
The fault codes “no” “AC” shows in the center display and an audible alarm sounds.
6. If 120 volts AC is available to the refrigerator, but is not operating correctly:
•
A fault code shows in the center display, and an audible alarm starts.
SET TEMP BUTTON
Summary of Contents for Canyon Star 2021
Page 1: ...2021 sm ...
