2008
Torrey Pine Fifth Wheel
by Newmar
8:5
MANUAL EXTENSION AND RETRACTION
Shaft end-mounted motors
If the motor is mounted on the ends of the
slide out shaft, use the following
directions:
1.
Access must be gained to the
TRANS-TORQUE bushing coupling
at the end of the slide out gear motor.
2.
Using a 1/2" drive – 11/2" open end wrench and a 1/2" drive ratchet
wrench, loosen the 11/2" nut. This will require approximately 11/2 turns.
The nut is a standard right hand thread. After the initial release, the nut
will turn for a partial turn, and then will release again as you turn the
wrench. This second release is required to loosen the TRANS-TORQUE
bushing from the shaft.
Shaft center-mounted motors
If the unit is equipped with the K-900 slide out motor which is mounted near
the center of the slide out room, use the following directions:
1.
Access must be gained to the slide out motor located in the center of the
slide out room.
2.
The manual extension or retraction
requires only a 5/8" socket and
ratchet wrench. By placing the
socket on the 5/8" hex nut located
on the gear box of the K-900 motor,
the slide out can be moved in either
direction by turning the hex nut.
3.
If the slide out does not move by
using the hex nut, the room can also
be extended or retracted by using
the procedure described for the
shaft end- mounted motors. If the
room is moved using this method,
the correct torque on the 11
⁄
2"
trans-torque nut is 125 foot pounds
maximum.
Summary of Contents for torrey pine 2008
