EDH0162En1040 – 06/99
1.20
MM4005
Introduction
System Setup
This section covers motion control system set up and preparing use it.
First all necessary cables must be connected and the controller must be
properly configured. This set up procedure configures a minimal system,
similar to Fig. 1.11.
Fig. 1.11
— A minimal control system.
NOTE
If you have not already done so, carefully unpack and visually inspect
the controllers and stages. Please save the packing material, in case you
have to ship the controller in the future.
Place all components on a flat and clear work surface. Check visually for
any sign of damage and if found, report immediately to the carrier.
NOTE
The front two “legs” of the chassis have a tab that, if rotated 90° forward,
place the controller in a slightly angled position. To return the controller
to horizontal position, lift the front side, pull on the tabs and return
them to the original position.
CAUTION
No cables should be connected yet to the controller.
1.4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com