4
Setting Up the Meter
Installing the Battery (Fig 2)
Carefully remove the meter from the
carrying case making sure you don’t lose
the small screwdriver and detergent in a
small plastic bag.
To install/change the battery, do the
following:
1. Insert your thumb in the recessed
area of the battery compartment
door and pull it away from the
display.
2. Snap the 9V alkaline battery into the
battery clip.
3. Place the battery clip/battery
assembly at the top of the battery
compartment.
3. Replace the battery compartment
door and snap into place.
Figure 2. Installing the Battery
PHH-60 and PHH-80
pH/Conductivity Meter