Hardware Installation
4.Now the PC connections will be made with the PS/2
Keyboard, Mouse and 15-pin monitor (VGA) connections to
the NEWSTAR all-in-one cable converter. Connect a cable
with the male side to the rear panel of the NS-211KA unit
to the connector labeled PC1. Repeat this for all PCs.
5.Using the audio cable,connect one end of the male 3.5mm
plug to the speaker out jack of your sound card or computer
and connect the other end to the speaker in jack of your
NS-211KA. Repeat this for all PCs.
Hardware Installation
6.To finish the hardware installation,connect the microphone
cables from your computers to the NS-211KA unit. Using a
second audio cable, connect one end of the male 3.5mm
plug to the microphone out jack of your sound card or
computer and connect the other end to the Microphone In
jack of your NS-211KA. Repeat this for all PCs.
7.Now make sure to verify all cables, Especially keyboard
and mouse cables should be checked because they are
easily switched due to use of the same type of connector.
8.Attach the power supply to the NS-211KA unit and plug it
into the mains. Now you will see the LED for Port 1 light up,
and you will hear a beep. Switch on your Monitor.
9.Now power up all computers simultaneously, the first
computer will be shown on the monitor. You may check if
the mouse and keyboard work after the system has booted
up. If this is OK, use the Select button to select the other
computer and verify the functionality in the same way. In
case you find errors, first check all cables for proper
connections.
DC9V, 600mA Adaptor(optional)
5
6
NS-211KA
NS-211KA
keyboard
VGA
mouse
audio
microphone
