Specifications
17044
640x480
25 frames/sec
PAL/NTSC
3 – 4.5 V
3xAAA (LR03)
7 / 6
SD (4 Gb)
40 min
70x50x40
100 / 65
Digisight series digital riflescopes
Quantum
series thermal imagers
APEX
series thermal sights
DFA75 / DN55
digital front attachments
Recon, Hornet digital monoculars
Ranger 5x42/Ranger Pro 5x42 digital monoculars
Model
Recording resolution, pixel
Frame frequency
Video signal standard
Power supply
Battery type
Operating time with one set of batteries
(stand-by/recording mode), hour
Type of memory card (max. capacity)
Recording time with a 1 Gb card
Dimensions, mm
Weight (with/without batteries), g
Compatible with the following models
Package contents
Video recorder
CVR640
Video cable to attach to Digisight/Hornet
Video cable to attach to Recon/Ranger
SD memory card
USB
cable
Weaver ¼'' adaptor
User manual
For improvement purposes, design of this product is subject to change.
Overview
Video recorder
CVR640
is a portable electronic unit designed to record the image
produced by various digital NV devices equipped with a video out.
The unit has a number of features such as:
Connectivity with most Newton, Pulsar or Yukon digital NV devices
Long operating time – up to seven hours
Recording video signal to the hard disc of a PC
User choice of video signal format - PAL/NTSC
Multiple ways to attach the unit to NV devices
Compact size and low weight
Components and Controls
1. «Rec» Record button.
2. «ON» button.
3. Mount for Weaver rail.
4. Light emitting diodes (LED).
Battery installation
Slide the cover of the battery compartment in the direction shown
on the cover and remove it.
Install three AAA type batteries (inc. NiMH rechargeable batteries)
according to the polarity markings inside the battery compartment.
Replace
the battery cover
.
Connection and video recording
Insert the SD memory card as shown in pic. 1.
Connect one plug of the video cable to the “Video In” jack (
5
) of the CVR640,
the other to the “Video Out” of a digital NV device (refer to the connection
schemes below).
Start the CVR640 by pushing the “ON” (
2
) button – a blue LED (
4
) will blink
rapidly for three seconds and will light up.
Turn on your night vision device.
Push the “Rec” (
1
) button to begin recording – the blue LED will start blinking.
To stop video recording push the “Rec” (
1
) button. The blue LED will cease
to blink.
5.
Video In.
6. Slot for SD memory card.
7. USB port.
2
3
1
5
4
6
7
Connection to
Recon/Ranger
1
Pic. 2a
Pic. 1
ENGLISH
Summary of Contents for cvr640
Page 21: ......
