1 9
Reversing the Door Swing
1. Make sure that your refrigerator is unplugged.
2. Pry the hinge cover up and off, remove the three screws that secure the upper hinge to the
door, then remove the hinge.
3. Remove the refrigerator compartment door from the cabinet.
4. Remove the two screws that secure the center hinge.
5. Remove the freezer compartment door.
6. Remove the screws that secure the lower hinge to the right side of the cabinet, then remove
the hinge.
7. Remove the washer and nut that secure the pin shaft to the right hole on the lower hinge,
then remove the shaft
8. Insert the pin shaft into the left hole on the lower hinge, then secure the shaft with the
washer and nut.
9. Install the lower hinge on the left side of the cabinet.
10. Remove the screw that secures the door stop from the bottom right of the freezer
compartment door, then remove the door stop and install to the bottom left side.
If you require any technical guidance or find that the product is not operating as intended, please see the
Troubleshooting
section of this manua
13. Remove the center hinge screw hole plug on the left side of the cabinet, then install in the
screw holes on the right side of the cabinet.
14. Install the center hinge to the left side with the two screws you removed previously.
15. Get the left door stop from the accessory bag, install it on the bottom left side of the
refrigerator door.
16. Install the Refrigerator compartment door.
17. Move the door bushing from the top right side of the Refrigerator door to the top left side
of the door. And move the left hole cover to the right side.
18. Remove the screw that secures the hinge screw hole cover from the top left side of the
cabinet, remove the cover and secures the cover on the top right side of the cabinet.
19. Secure the upper hinge to the top left side of the cabinet with the three screws you
removed previously. Before you tighten the upper hinge screws, make sure that the top of the
door is level with the cabinet and that the rubber gasket makes a good seal.
20. Install the hinge cover over the hinge on the top left side of the cabinet.
3
