Copyright © 2023 NexCOBOT Co., Ltd. All Rights Reserved.
31
NEX 813 User Manual
Chapter 3: BIOS Setup
SIO Configuration
This section is used to configure the serial ports.
Advanced
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
View and Set Basic properties
of the SIO Logical device.
Like IO Base, IRQ Range, DMA
Channel and Device Mode.
AMI SIO Driver Version : A5.09.01
Super IO Chip Logical Device(s) Configuration
[*Active*] Serial Port 1
[*Active*] Serial Port 2
[*Active*] Serial Port 3
[*Active*] Serial Port 4
[*Active*] Serial Port 5
[*Active*] Serial Port 6
WARNING: Logical Devices state on the left side of the
control, reflects the current Logical Device state. Changes
made during Setup Session will be shown after you restart
the system.
[*Active*] Serial Port 1 to [*Active*] Serial Port 6
Enters the submenu of [*Active*] Serial Port 1 to [*Active*] Serial Port 6.
AMT Configuration
This section is used to configure AMT settings
Advanced
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
When disabled AMT BIOS
Features are no longer
supported and user is no longer
able to access MEBx Setup.
Note:
This option does not disable
Manageability Features in FW.
AMT BIOS Features
[Enable]
AMT BIOS Features
Enables or disables AMT BIOS features. When disabled, user will no longer
be able to access MEBx setup.