Copyright © 2018 NEXCOM International Co., Ltd. All Rights Reserved.
69
TPPC 2210 and TPPD 2200 Series User Manual
Chapter 4: BIOS Setup
Advanced
Version 2.16.1243. Copyright (C) 2013 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enables Legacy USB support.
AUTO option disables legacy
support if no USB devices are
connected. DISABLE option will
keep USB devices available
only for EFI applications.
USB Configuration
USB Devices:
1 Keyboard, 1 Mouse, 3 Hubs
Legacy USB Support
XHCI Hand-off
EHCI Hand-off
USB Mass Storage Driver Support
USB hardware delays and time-outs:
USB transfer time-out
Device reset time-out
Device power-up delay
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[20 sec]
[20 sec]
[Auto]
Legacy USB Support
Enabled
Enables Legacy USB.
Auto
Disables support for Legacy when no USB devices are
connected.
Disabled
Keeps USB devices available only for EFI applications.
XHCI Hand-off
This is a workaround for OSs that does not support XHCI hand-off. The
XHCI ownership change should be claimed by the XHCI driver.
USB Configuration
This section is used to configure the USB.
EHCI Hand-off
This is a workaround for OSs that does not support EHCI hand-off. The EHCI
ownership change should be claimed by the EHCI driver.
USB Mass Storage Driver Support
Enables or disables USB mass storage driver support.
USB Transfer Time-out
The time-out value for control, bulk, and Interrupt transfers.
Device Reset Time-out
Selects the USB mass storage device’s start unit command timeout.
Device Power-up Delay
Maximum time the value will take before it properly reports it self to the
Host Controller. “Auto” uses default value: for a Root port it is 100 ms, for
a Hub port the delay is taken from Hub descriptor.
