2
FORM NO. L-20118-A-0601
FIGURE 1
INSTALLATION
1.
Provide a flat mounting surface below the rotor disc
(See Figure 1).
2.
Drill and tap mounting surface. See Figure 2 and
Table 2 for hole locations.
3.
Using socket head cap screws (#10-24 for Model
625 and 1/4-20 for Model 1000) mount brake (See
Figure 1).
NOTE: Allow .030 clearance between Rotor Disc
and Brake Housing (See Figure 2)
4.
Tighten cap screws to 5 ft/lbs torque for Model 625
and 9 ft/lbs torque for Model 1000.
Rotor Disc
Brake
Mounting
Surfaces
FIGURE 2
TABLE 2
Dim.
625
1000
A
7/32 in [5.57 mm]
9/32 in [7.41 mm]
B
5/16 in [7.94 mm]
1/4 in [6.35 mm]
C
5/8 in [15.87 mm]
1-1/8 in [28.57 mm]
D
1-1 /4 in [31.75 mm]
1-5/8 in [41.27 mm]
E
5/16 in [7.94 mm]
.3/8 in [9.52 mm]
AIR CONNECTIONS
Route air line from brake air inlet to control valve. (Model
1000 has 1/8 NPT inlet, for Model 625 use Air Hose,
Product No. 857000.)
For quick response, a short air line between the control
valve and brake is recommended.
®
DIST
. AUTORIZADO
MEX
(55) 53 63 23 31
QRO (442) 1 95 72 60
MTY (81) 83 54 10 18
ventas@industrialmagza.com
