LIGHTING INSTRUCTIONS
WARNING: IMPORTANT!
WARNING
Failure to open grill lid during the lighting
procedure could result in a fire or explosion
that could cause serious bodily injury, death,
or property damage.
WARNING
Never
lean over the grill cooking area while
lighting your gas grill. Keep your face and
body a safe distance (at least 18 inches) from
the cooking grid surface when lighting your
grill by match.
BEFORE LIGHTING…
Inspect the gas supply hose prior to turning
the gas “ON”. If there is evidence of cuts,
wear, or abrasion, it must be replaced prior to
use. Do not use the grill if the odor of gas is
present. Only the pressure regulator and
hose assembly supplied with the unit should
be used. Never substitute regulators for those
supplied with the grill. If a replacement is
necessary, contact the factory for proper
replacement.
Hand tightens the regulator (type QCC1) onto
the tank. Leak check the hose and regulator
connections with a soap and water solution
before operating the grill(Do not use tool to
attach regulator / hose assembly to propane
tank.) (see assembly instruction page 9).
TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on
the gas supply from the LP tank. Always keep
your face and body as far from the grill as
possible when lighting.
Your grill has an exclusive patented built-in
ignition. The igniter is built in to the valve. To
ignite each burner simply push and turn the
control knobs to the HI setting, you will hear
the valve click as it sends a spark to the pilot
flame. If the burner does not light wait 5
minutes for any excess gas to dissipate and
then retry.
Flame Characteristics
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment; however, variations
in the local gas supply may take minor adjustments
necessary.
Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting. If any of these conditions
exist call our customer service line. If the flame is
yellow, it indicates insufficient air. If the flame is noisy
and tends to lift away from the burner, it indicates too
much air.
TO MATCH LIGHT THE GRILL:
If the burner will not light after several attempts then the
burner can be match lit.
If you’ve just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away from
the grill as possible. Insert a lit extended match or
lighter through the cooking grids to the burner. Press the
control knob and rotate left to the HI setting, continue to
press the knob until the burner ignites. Burner should
light immediately. If the burner does not light in 4
seconds turn the knob off, wait 5 minutes and try again.
Keep a spray bottle of soapy water near the gas supply
valve and check the connections before each use.
I15Y06P-1
20
