FOREWORD
Foreword
This manual is intended to help you to install and operate the NXtension-ES4
Expander Board.
Please have a look the page devoted to NXtension-ES4 on NEXO website
http://www.nexo-
sa.com/asp/catalogue/products.asp?linkid=284&prodcode=NXtension-ES4
before
installing your product to check if the release enclosed in the enclosed CDROM is the
latest.
This product is intended for use with the NX242 digital TDcontroller. Do not try to
install it in an NX241 as damage could result.
NXtension-ES4 Expander Board at a glance:
o Double DSP resources & Setup memory of the NX242 TDcontrollers.
o Remote Control potentials via WLAN and Internet, 100% Ethernet and TCP/IP
compatible.
o NX242 TDcontroller full remote control including Input/Output meters & protection
monitoring
o 4x Digital audio inputs from 64 uncompressed channels of 24bit/48kHz of audio
transmission over Ethernet. (EtherSound protocol)
o 4x NX242's processed digital audio outputs to 64x uncompressed 24bit/48kHz
channels of audio transmission over Ethernet.
Unpacking
The NXtension Expander Board package should contain:
-
the NXtension-ES4 Expander Board
-
2x M3x4 screws for replacing blank panel (rear of the NX242)
-
3x M3x5 screws for fastening the NXtension Expander Board in the NX242
-
1x CD ROM containing this manual, the LOAD needed for updating the firmware
of the NX242 and the ESmonitor software to control the NX242
-
this
manual
NXTENSION USER MANUAL
DOCUMENT REVISION 150305
PAGE
5
