3. Align the (3) holes at the base of the marine light with the mounting points.
4. Place a bolt with a lock washer and flat washer into each mounting point. Tighten down with a 7/16”
socket wrench.
Operation
The M650 is controlled using an IR programmer that is normally provided with the beacon. It also has an
on-board manual user interface on the bottom that can be used to change settings.
The IR programmer and user interface can be used to perform the following functions:
M650 mounting alignment.
Securing the M650 solar marine light.
IR
programmer.
On-board user interface.
17