32
33
Consult the vehicle owner's handbook for location of anchorage fittings or
anchorage points and the possible use of spacers. Some vehicles may have an
anchor fitting fitted by the vehicle manufacturer. If anchorage points cannot be
found refer to car manufacturer or local child restraint fitting station or traffic
authority for optimum position of anchorage point and the use of spacers.
IMPORTANT:
THE ATTACHMENT CLIP COVER MUST ALWAYS BE USED AS IT PREVENTS THE RISK
OF INCORRECT FITMENT OF THE ATTACHMENT CLIP TO THE ANCHOR FITTING.
ALWAYS ENSURE THAT THE ATTACHMENT CLIP IS CORRECTLY ENGAGED TO THE AN-
CHOR FITTING AND NOT HOOKED OR FITTED TO ANY OTHER OBJECT BEFORE EACH
USE OF THE RESTRAINT. THIS IS ESPECIALLY IMPORTANT IN VEHICLES SUCH AS
STATION WAGONS, VANS, HATCH BACKS OR VEHICLES WITHOUT A FIXED PARCEL
SHELF, SINCE THE ANCHOR POINT IS USUALLY NOT VISIBLE.
IMPORTANT INSTALLATION NOTE:
In some vehicles the anchor fitting in the rear vertical panel can only be installed
in one way. Please refer to vehicle owner's handbook or a child restraint fitting
station for correct method.
Extension Strap distance to be measured.
Length 300mm (Use Safe-n-Sound part 0035 or equivalent)
Length 600mm (Use Safe-n-Sound part 0036 or equivalent)
Available from all major child restraint retailers.
The shaded areas of this diagram illustrate the possible locations of the anchor
fitting. Within each shaded area is an anchor fitting showing the correct way to
install the fitting. Ensure the anchor fitting is aligned as illustrated unless stated
otherwise in the vehicle Owners handbook.
Distance to measure to
the anchor point
Correct engagement of
attachment clip to anchor
fitting when attachment
clip cover is used.
Adjustable Upper
Anchorage Strap
45
°
PRE-INSTALLATION OF
ANCHOR FITTING
PRE-INSTALLATION OF
ANCHOR FITTING
Front of Vehicle
