- Installation instructions for supplementary outriggers -
Via Mediterraneo, 6 - 42022 - Boretto - Reggio Emilia - Italy
Tel. +39 - 0522-96 30 08 - Fax +39 - 0522-96 30 39
info@maxiliftcrane.com
- 12 -
- Tighten slightly the screw (
2
), paying attention that the collar is
completely leaning to the below part of the cylinder sleeve, in
case helping by some slight rebound-proof mallet strokes.
- Then tighten definitively the screw by the torque wrench to the
driving torque shown in the proper table (Tab. 1).
Stabilizer
Cylinder
Screw type Wrench
Driving torque
model
diameter(mm)
(mm)
(mm)
daN-m
Lbs-ft
GR. 0/ML
70
TCEI M12
10
12
85
cl. 12.9
Gr. 1
85
TCEI M14
12
20
145
cl. 12.9
Gr. 2 / Gr. 3
95
TCEI M16
14
30
220
cl. 12.9
7.3 Warnings and dangers
1.
The non-respect of tightening torques puts at risk stabilizer’s
safety. Before tightening, check that the screw
and its threaded hole made in the collar are
degreased and clean.
2.
Check that in the new working position chosen,
the stabilizer cylinder is still correctly housed
into its cylinder sleeve. That happens when the
cylinder leans on both centering bands made
inside the sleeve (Pict. 15).
3.
If during the above operations the sharp profiles
made in the internal cylindrical surface of the
collar are accidentally damaged, take care of
replacing the collar by a new one.
4.
The collar must not be welded in any way.
5.
The prescription decal, indicating the obligation
to use the torque wrench, and the driving torque
value, is to be applied near the collar after the
installation is finished, and anyway after painting,
so that it is completely visible.
Pict. 13
Pict. 14
Pict. 15
YES
NO
Table 1
