- Installation instructions for supplementary outriggers -
Via Mediterraneo, 6 - 42022 - Boretto - Reggio Emilia - Italy
Tel. +39 - 0522-96 30 08 - Fax +39 - 0522-96 30 39
info@maxiliftcrane.com
- 13 -
7.4 Periodical checking
-
Weekly:
Carry out a visual checking making sure that the cylinders did not move upwards or that, with
cylinders in transport position, there is no clearance between the locking collar and the sleeve; in
case one of the above situations occurs, have screw tightening checked by an authorized workshop.
-
Yearly:
Have screw tightening checked by an authorized workshop and, if necessary, restore it tightening
by torque wrench, according to what shown in Tab. 1.
Each operation beyond what described has always to be approved by
Next Hydraulics’
Technical
Department, whom you have to apply to for any clarification and further information required.
8 - ASSEMBLING AND DISASSEMBLING OUTRIGGER CYLINDERS SERIES “4”
STANDARD OR “P” VERSION WITH SYSTEM BY STOP RING
Assembly
(see Pict. 16-17)
STEPS
1)
Take the new stop round
bar (
1
) and bend it slightly
close to the hooking notch
(drawing)
2)
Grease by a brush the
cylinder sleeve and the
cylinder liner in the area
where it slips into the
sleeve
3)
Slip the cylinder into the
seat until the groove and
the hooking hole coincide
with the slit in the front of
the cylinder sleeve
4)
Hook the stop round bar,
grease it and screw by the
lever (
3
) until everything is
in its place, and setting the
fittings inlets in the desired
position
5)
Lock the rotation by the
dowel (
2
); use Loctite 242
to prevent unscrewing
6)
Degrease the outside and
seal the “
A
” and “
B
” areas
by silicone (black Saratoga
for bodywork).
7)
Assemble all fittings. Both greasing and protection against possible water seepages are
important for an easy disassembly.
Pict. 16
DISASSEMBLY
ASSEMBLY
1/2"gas
1/2"gas
L=~600 mm
L=~600 mm
3/8"gas
Grease
Bend slightly
