- Installation instructions for supplementary outriggers -
Via Mediterraneo, 6 - 42022 - Boretto - Reggio Emilia - Italy
Tel. +39 - 0522-96 30 08 - Fax +39 - 0522-96 30 39
info@maxiliftcrane.com
- 14 -
IMPORTANT
For a following easy disassembly, it is important to be particularly careful during the greasing
and sealing operations, in order to grant an effective protection against water seepages.
Disassembly
(see Pict. 16-17)
STEPS
1)
Disassemble cylinder
piping, which inhibit its
extraction
2)
Remove the sealing
silicone from the “
A
” and
“
B
” areas
3)
Unscrew the dowel (
2
),
in order to release the
cylinder
4)
Insert the lever (
3
) for
the disassembly; make
the cylinder turn until
the end of the stop round
bar (
1
) comes in
correspondence of the
slit on the sleeve
5)
Lever by a screwdriver,
so that the round bar,
going on turning, comes
out of the slit
6)
At this stage, when the
round bar is out, the
cylinder can be extracted.
IMPORTANT
For a following easy disassembly, it is important to be particularly careful during the greasing
and sealing operations, in order to grant an effective protection against water seepages.
Pict. 17
DISASSEMBLY
ASSEMBLY
Grease
Bend slightly
L. to be
defined
L=~600 mm
L=~600 mm
1/2"gas
1/2"gas
