022
www.ruggedaq.com
DATALOGGER
NI2400
NI2400
023
www.ruggedaq.com
DATALOGGER
NI2400
NI2400
2
2
SETUP
POWERING THE DATA LOGGER
The NI2400 is supplied not powered to avoid that during transport the backup battery will discharge.
To begin working with the NI2400 proceed as follows:
• Connect external powering (battery charger or photovoltaic panel);
ATTENTION: Do not invert battery polarity, otherwise the data logger may be damaged
or stop working.
Default NI2400 Settings
The network card is setup from as follows:
IP Address:
192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
DNS1: 0.0.0.0
DNS2: 0.0.0.0
To connect with the NI2400 is necessary to setup PC network card in the same class of the
data logger, but with different IP (eg. 192.168.1.200).
Direct connection (LOCAL) to the Datalogger
To connect and manage the NI2400 through its on-board web pages, after the proper con-
figuration of PC network card, connect the PC to the NI2400 through an Ethernet crossover
cable (supplied). Once connected through the supplied cable, open any internet browser
and put, in the address bar, NI2400 IP address (default 192.168.1.100).
After a few seconds you will be asked for the data logger access credentials.
NOTES:
• The NI2400 is compatible with the main internet browsers (FireFox, IE9, Safari, Chrome).
FireFox is recommended to manage the NI2400.
•First page upload can take some time.
Following are the default credentials:
User “Admin” User
User: Admin
User: User
Psw: Admin
Psw: User
REMOTE CONNECTION TO THE DATALOGGER
This manual contains all basic information to properly connect the NI2400 to the network
through ethernet connection.
There is also a description of the procedure to set the logger and connect it through DHCP.
IP Computer Settings
Overview
Here you will learn how to set the computer IP address to allow the connection with the
NI2400.
Description
Open control panel and then: Network and Internet – Network Centre and Sharing
