0108
www.ruggedaq.com
DATALOGGER
NI2400
NI2400
0109
www.ruggedaq.com
DATALOGGER
NI2400
NI2400
AN_1_A
,
AN_1_B
and
AN_2_B
are e xactly the alias for the data source that must be
configured in the Exosite portal in the next step.
ADD DATA SOURCES
On the Exosite portal, go to the device page by clicking on
Device
menu item. In the
device list you should find the device (NI2400 in this example) added on chapter 1.
By clicking on this device you should reach the configuration page of this device. In
the top right of this page you have the data list where you can see the data source
associated to this device. At the moment the list should be empty; you can add data
source with the button
Add Data
.
Here you should add all the data source configured on the physical device in the first
paragraph in this chapter
In this example the data source will be added
AN_1_A, AN_1_B
and
AN_2_A
.
By clicking on
Add Data
you get the following page:
WARNING: Only use “A-Z,a-z,0-9,_” characters in Alias and channel identification.
In this page it is important that following field must be set in the following way:
Data Source Format
: string
Alias
: the name of the input configured on omnia in chapter 2,
AN_1_A
in this example
The field
Data Source Name
can be used to insert a description of the input; the other
field should be left to default.
After saving the configuration you should repeat the procedure for all the input config-
ured on omnia during chapter 2.
After this steps, come back to Device page and by clicking on device name you should
see the list of all the data source added to this device, in this example
AN_1_A
,
AN_1_B
and
AN_2_A
:
Figure 99
Figure 100
Figure 101
Figure 102
Figure 103
5
5
