TROUBLE SHOOTING
The Dash Cam will not stay
fixed to the mirror, using the
suckers alone.
I cannot insert the MicroSD
card.
I cannot remove the MicroSD
card.
I can only record a few
minutes of video on my
MicroSD card.
I cannot save files to the
memory card when the
Dash Cam is connected to
my computer under
Mass Storage mode.
No power to my Dash Cam,
but it works upon my PC.
My Dash Cam shuts down by
itself after a while.
The screen blanks after a few
minutes upon my
Dash Cam.
The battery will not charge.
Make sure that the mirror is clean and then slightly moisten the
suction cups. Apply the Dash Cam to the existing mirror making
sure that the Dash Cam sits upon the flat glass of the existing
mirror and is not touching the raised edge of the existing mirror.
MicroSD card are very small and require delicate use. Align the
card with the diagram shown upon the Dash Cam and insert the
card until you feel a slight spring resistance. You now need to push
the card, using your finger nail, until you hear and feel a small
latch. Release pressure and the card will stay retained within the
device. Use the edge of a small coin if you have difficulty.
With the card previously installed, you now need to push the card
further inwards slightly, using your finger nail, until you hear and
feel a small latch.
Use the edge of a small coin if you have difficulty.
Release pressure and the card will spring out sufficiently for you to
take hold of it.
Change the recording size (Video Length function) to a smaller
128
size. Increase the size of the MicroSD card. Max
GB.
Correct, the Dash Cam is a 'read-only' device.
It is not recommenced to save files from other sources to the same
memory that you will use for recording within the Dash Cam, as
these may have a negative effect on the performance of the
Dash Cam.
The cigarette power cable is not working. Inspect the fuse in the
Car Power plug. Replacement fuse = 2A 20mm type. If the fuse is
found to be blown, inspect the power cable for damage which may
have caused the fuse blow.
Either the battery has gone flat, there is no power to the Dash Cam
and the Auto Power Off period has been triggered or Parking Mode
has been turned on and no vehicle movement has been detected
for 5 minutes.
The screen saver is set to ON. Change settings to OFF if required.
Default setting is off.
d
Ensure the Dash Cam is connected to a reliable power source an
that the supplied Car Power Cable is being used, with the Power
LED lit.
PROBLEM
SOLUTION
34
Summary of Contents for Mirror
Page 1: ...Instruction Manual ...
