MVS PRO
Mu lti -Vision Set PRO
Oper atin g I nst ruc tio ns
2. Lower the portable DVD player and placing the groove on the backplate of the
portable DVD player over the raised slot in the m iddle of the headrest mount.
See relative diagrams. Gently push the screen all the way down until the lock
clicks.
Fitting and use of the mirror stand in car
Before installation, rip off the films of the two cupules first. Then choose the
desired place of the windshield and clean it. Put the cupules onto the place and
fix them by pushing down the two small handles on both rear sides. Then the
mirror stan d will be fixed firmly. See diagram below.
Fitting the portable DVD player to the mirror stand
1. Turn the portable DVD player mounting plate on the mirror stand to the
suitable direction. Slide the portable DVD player in place by using a sliding
action. The T shaped raised slot in the middle of the mounting plate must
engage with the guide(s) on the back of the portable DVD player. See
diagram below.
Pls. Note that the mirror stand has an integral latch to hold the portable
DVD player securely in place. Ensure this latch is engaged by hearing it
click in to place.
2. Once the portable DVD player is in position, adjust the viewing angle and
screen direction for optimum pleasure by gently moving the portable DVD
playe r in either the rotational, fwd/aft or up and down directions.
See diagram below.
Removal of the products
1. Removal of the portable DVD player from the centre arm, headrest mount
and mirror stand is as follows:
Press the latch release button and slide the portable DVD player upwards
to disengage it from the centre arm, headrest mount or
stand.
mirror
2. Removal of the centre arm, headrest mount and
stand is the reverse
of the installation method.
mirror
Fitting portable DVD player to headrest mount
1. These instructions assume the backplate is insta lled on the rear of the
portable DVD player, as introduced above.
Holding the portable DVD player the correct way up and by the edges, offer
the rear of the screen up to the centre of the hea drest mount. See diagram
below.
Page 4
Page 5
MVS02-ENG-NB-A/1
Caution:
Please make sure that before installation, the place for the cupules should
be clean and smooth. Or else the mirror stand will fall off easily.
Note:
When removing the
stand, pull up the two small handles first. And
lift the two eared rubber on the outer side of each cupule. Then the
stand can be removed conveniently.
mirror
mirror
版 本 ：
A/1
日 期：
200 5 .07 .13
Ref No.
SP-MVSPRO-PD-DWG-00 2
：
MVS PRO
英文说 明书
制定： 鲍恩华
确认 ：李刚
批准： 洪伟 兵
广州矽 金塔 电子有限公 司
A/1
cupu le
mirro r
修 改点 ：把 部 分 “
” 这个 单 词 换 为 “
。 ”
文件使用
"pdfFactory Pro"
试用版本创建
www.fineprint.cn
