Thanks for purchasing this multi-vision set for portable DVD player.
It is designed to install the DVD player to car headrest or fix it in car
for in-car using.
Package contents
1
1 X Centre Arm
2
1 X Headrest Mount
3
1 X Mirror Stand
4
8 X Screws
6
1 X Plat Backplate
5
1 X Arcual Backplate
Operations
Fitting the backplate to the back of portable DVD player
1. The arcual backplate and the plat backplate attach to the back of the player
and allow them to be used with centre arm, headrest mount and mirror
stand. Make sure the backplate is attached to the right DVD player type and
the right way round. See diagrams below.
2. Place the backplate on the back of the player and using 4 screws
provided to screw it onto the player. Do not over tighten the screws.
See diagram below.
Page 1
Fitting and use of the centre arm
1. Undo the thumb wheel to open up the jaws of the centre arm. See diagrams
below.
2. Place the jaws around the headrest stations in order to position the end
of the arm in the most central position of the car and then re-tighten the
thumb wheel. See diagram below.
3. Turn the portable DVD player mounting plate on the centre arm vertical
and to face the rear of the car. Slide the portable DVD player in place
by using a vertical sliding action from the top downwards. The T shaped
raised slot in the middle of the mounting plate must engage with the guide
(s) on the back of the portable DVD player. See diagram below.
Pls. note the centre arm has an integral latch to hold the portable DVD
player securely in place. Ensure this latch is engaged by hearing it click
in to place.
4. Once the portable DVD player is in position, adjust the viewing angle and
screen direction for optimum pleasure by gently moving the portable DVD
player in either the rotational, fwd/aft or up and down directions.
The ratchet will hold the product in place at the desired position. See
diagram below.
The centre
arm can be adjusted to the optimum length and fixed by rotating the
telescopic knob.
Fitting headrest mount and DVD player
The headrest mount has been designed to fit the wide variety of shapes
and sizes of the headrests in modern cars. The foam pad allows you to
set the angle of the screen and will eliminate vibration when the car is
moving.
1. Decide which headrest to use.
2. When used to headrest, ensure the seat, seatback angle and headrest are
positioned to suit the front seat occupant follow the instructions of car
manufacturer.
3. Unfold the ties so they hang from the headrest mount. Do Not remove them
from the headrest mount completely.
4. Hold the headrest mount in the middle of the headrest itself, making sure
that the quick release mechanism is at the top. See diagram at next page.
Pass the two top straps over the top of the headrest and down the front
surface. See diagrams at next page. Pass the bottom two straps under the
headrest and pull them up to meet the straps at the top. See diagrams at
next page.
Page 2
Page 3
The top of the
backplate goes
to the top of
the player.
Suitable DVD
player type.
SDV17-
SERIES
SDV27-
SERIES
SDV37-
SERIES
SDV185-
SERIES
SDV77-
SERIES
制定：
确认 ：李刚
批准： 洪伟 兵
MVS PRO
英文说 明书
广州矽 金塔 电子有限公 司
文件使用
"pdfFactory Pro"
试用版本创建
www.fineprint.cn
