7.5.7 Insert pin (#08) through receptacle/ down rod assembly and
attach clip.
7.5.8 Tighten screw on side of receptacle.
7.5.9 Align the hub (#16) with the motor shaft, be sure the flat side
of the motor shaft matches up with the flat side of the hole in
the center of the hub. Press hub onto shaft until 3/8" (1cm) of
the motor shaft protrudes from the hub. Tighten set screw
with Allen Wrench included with the fan.
NOTE:
To prevent wobble, make sure the FLAT of the motor shaft is
aligned with the FLAT of the center of hub. The set screw should be
tightened against the center of the FLAT of the motor shaft.
7.5.10 Push retaining clip (#18) onto motor shaft (#13) until it is
firmly against the hub.
WARNING:
Failure to install the retain clip tightly against the hub as
described may cause separation of the hub during fan operation. Serious
injury may result. Consult a qualified installer if in any doubt about
installation procedures.
7.5.11 Push retaining knob onto motor shaft until it is firmly against
the hub.
7.5.12 Insert retaining pin (#06) into upper down rod holes. Then
slide pivot ball (#05) up and over retaining pin.
7.5.13 Align mounting cone (#03) slot with pivot ball key.
7.5.14 Lift completed motor and hub assembly to mounting bracket
on ceiling, and slip one hole on side of mounting cone over
hook on bracket.
7.5.15 With motor and assembly hanging from hook, connect fan
wires to the house wires using the three (3) wire nuts
included with fan.
White = positive
Black = negative
Green = ground
14
Copyright 2012 all rights reserved by Nextek Power Systems, Inc. in the United States and in other countries throughout the world.
Vari-Cyclone Ceiling Fan
Installation Manual
Models: 3/4-Blade Vari-Cyclone
7.0
INSTALLATION PROCEDURE