MANUAL
5203
If you want to receive the RC signal manually, hold down the “UP” button for
2 seconds. A signal symbol will flash at the bottom right corner of the screen.
When the signal is found, the symbol will stop flashing and will show permanent.
If you receive the signal, but you live in another Time Zone than where the signal
originates from, you can adjust the time zone:
• Push the switch at the left side to “SET TIME” (down), and then press SET
button to set the time zone
• Press Up/Down button to adjust value.
If you want to stop receiving the RC signal manually, press the “UP” button again.
The signal symbol will disappear and not show anymore at the corner of the
screen.
If you live in a zone where the signal cannot be found, the clock will work
normal by setting the time manually.
Please see the next page for the instructions how to do this.
1. Default time is 00:00(24hr).
2. Default Alarm is 00:00(24hr).
3. Default interval of snooze is 5minutes.
4. Default time zone is 0
If there is no RC signal provided in your country/area, you can set the
time manually as below procedure.
1. Push the switch at the left side to “SET TIME” (down), and then press
SET button to set the time zone.
2. Press Up/Down button to adjust value.
3. Press SET button second time to set hour
4. Press Up/Down button to adjust value
5. Press SET button third time to set minute.
6. Press Up/Down button to adjust value
TIME SETTING
