MANUAL
5203
7. Press SET button again to exit setting.
8. Push the switch to “LOCK” for changing mode to normal working.
When you live in a country/area where the clock should have signal, but the
clock is unable to receive a good signal, it can happen that the signal is disturbed
by other signals. For example dect phones or microwaves.
Another possibility is that the signal cannot reach the clock because it is blocked
by parts of the building.
For example a steel construction, or when the clock is inside a basement.
The signal is best received when the clock is close to a window.
There is a possibility to show the time in a 12hr view, or a 24hr view.
With a 12hr view, the clock will show the hours from 01-12 and PM in front
of it, if nothing is shown, than it is AM.
With a 24hr view, the clock will show the hours from 00-23.
1. Push the switch to “LOCK” (this is the standard/middle position of the switch
at the left side), and then press “12/24” button to change the time display.
The clock has a special white LED backlight.
The light will stay on for about 5 seconds, after you touch the top of the clock.
This touch button on top of the clock also functions as a snooze button when
the alarm is ringing.
TIME DISPLAY
12/24
SNOOZE/
LIGHT
