20
Step 16: Attach the Vertical Mounting Bars
to the TV.
Before you begin, hand thread
screws found in bag labeled “TV Mounting
Screws/Spacers” into the threaded inserts
on the back of your TV to determine the
correct screw diameter (M6 or M8). The
length of the screw required will depend on
whether the TV has a flat/unobstructed or
irregular/obstructed back. Follow diagram
“A”
for TV’s with flat/unobstructed back.
Use diagram
“B”
for TV’s with irregular/
obstructed back. The diagrams can be found
on the following page.
Step 17: Mount the TV (with the Vertical Mounting Bars attached) to the Screen Back Plate.
Each
Vertical
Mounting Bar
has “hooks” on either end that allow the bars to “hang” on the
Screen Back Plate.
Lift the TV
onto the
Screen Back Plate.
Center the TV. Be sure that both the upper and lower set of “hooks” fully engages
with the
Screen Back Plate.
Step 18: Insert the Screen Locks into both Vertical Mounting
Bars.
The
Screen Locks
will be placed into the lower “hook”
that is just below the
Screen Back Plate.
Step 19: Tighten the Screen Locks.
Using a Phillips head
screwdriver, tighten both
Screen Lock Screws
into the
underside of the
Screen Back Plate.
This will lock your TV onto
the TV Lift. You have now successfully attached your TV.
Step 20: Attach the Cable Re-coiler to your cables.
Mount the provided Cable Re-coiler towards the top of
your enclosure on the same side as the control box. Attach the cable to the bundle of wires that run to the
back of your TV. This will help aid the cables back into the enclosure as the lift fully retracts. Test operate the
lift and be sure that all wires are clear of the lift, so they do not get “hung up” when the TV is moving in either
direction.
Congratulations your L-27i Lift System is now completed!
